Product ID:154675, FORMULA 77 SOLID BODY LATEX STAIN (SUPDAT)
MSDS Date:04/21/1994
FSC:8010
NIIN:00N057000
MSDS Number: BWRPC

KYANIZE PAINT

601 S HAVEN ST
BALTIMORE, MD 21224
US

Emergency Phone: 410-342-3641

Info Phone: 410-342-3636

Cage: 85520

KYANIZE PAINT

BALTIMORE, MD 21224 US

Telephone: 800-368-2076

Cage: 85520

1,2-PROPANEDIOL; (PROPYLENE GLYCOL)

CAS: 57-55-6

RTECS: TY2000000

Fraction By Weight: 1-5%

OSHA PEL N/K

ACGIH TLV: N/K

PIGMENTS

OSHA PEL N/K

ACGIH TLV: N/K

1.395

RTECS: 9999999VO

OSHA PEL N/K

ACGIH TLV: N/K

ING BELOW ACCEPTABLE LIMIT, LEL BELOW STATED LIMIT,

RTECS: 9999999ZZ

ON SURFACES COATED WITH THIS PRODUCT.

RTECS: 9999999ZZ

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:RPTS HAVE ASSOC RPTD & PRLNGD OCCUP
OVEREXP TO SOLVS W/PERM BRAIN & NERV SYS DMG. INTENTIONAL MISUSE BY
DELIB CONC & INHAL CONTENTS MAY BE HARMFUL/FATAL. DO NOT BRTH
VAPS/SPRAY MIST. WEAR A NIOSH/MSHA APPRVD PROPERLY FITTED RESP
DURING & AFTER APPLIC UNLESS AIR MONITORING DEMONSTRATES VAP/MIST
LEVS (EFTS OF OVEREXP)
Explanation of Carcinogenicity:NOT RELEVANT.
Effects of Overexposure:HLTH HAZ: ARE BELOW APPLICABLE LIMITS. FOLLOW
RESP MANUFACTURER'S DIRECTIONS FOR RESPIRATOR USE. BASED ON
PRESENCE OF COMPONENTS PRODUCT HAS LOW TOX BUT IS READILY ABSORBED
AND CAN CARRY OTHER MATERIA LS THROUGH INTACT SKIN, MAY BE HARMFUL
IF SWALLOWED, CAN BE IRRITATING TO EYES, MAY CAUSE SKIN IRRITATION.
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.

First Aid:EYE: FLUSH W/LUKE WARM WATER FOR AT LST 15 MINS. SEEK PHYS
IMMED. SKIN: FLUSH WASH W/COPIOUS AMTS OF LUKE WARM WATER. REMOVE
CONTAMD CLTHG PROMPTLY. CONT PHYS IMMED. INHAL: REMOVE EXPOS INDIV
TO FRESH AIR. RESTORE BRTHG IF REQD. CONT PHYS IMMED. INGEST:
RINSE MOUTH IMMED. GIVE EXPOS INDIV 6-8 OZ OF LIQ. (NEVER GIVE
ANYTHING BY MOUTH TO AN UNCON PERSON).DO NOT INDUCE VOMIT UNLESS
ADVISED BY(SUPDAT)

Flash Point Method:TCC
Extinguishing Media:USE MEDIA SUITABLE FOR SURROUNDING FIRE CONDITIONS
.
Fire Fighting Procedures:WEAR NIOSH/MSHA APPROVED SCBA AND FULL
PROTECTIVE EQUIPMENT .
Unusual Fire/Explosion Hazard:CONTAINERS EXPOSED TO INTENSE HEAT FROM
FIRES SHOULD BE COOLED WITH WATER TO PREVENT VAPOR PRESSURE BUILDUP
WHICH COULD RESULT IN CONTAINER RUPTURE.

Spill Release Procedures:NONE SPECIFIED BY MANUFACTURER.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling and Storage Precautions:KEEP FROM FREEZING. DO NOT STORE ABOVE
120F. DO NOT TAKE INTERNALLY. CLOSE CONTAINER AFTER EACH USE. KEEP
OUT OF REACH OF CHILDREN!
Other Precautions:NONE SPECIFIED BY MANUFACTURER.

Respiratory Protection:IN OUTDOOR/OPEN AREAS USE NIOSH/MSHA APPRVD MECH
FILTER RESP TO REMOVE SOLID AIRBORNE PARTICLES OF OVERSPRAY DURING
SPRAY APPLIC. IN RESTRICTED VENT AREAS USE NIOSH/MSHA APPROVED
CHEM-MECH FILTERS DES IGNED TO REMOVE COMBINATION OF (SUPDAT)
Ventilation:USE VENT AS REQD TO CNTRL VAP CONCS.PROVIDE GEN
DILUTION/LOC EXHST VENT IN VOL & PATTERN TO KEEP TLV OF MOST HAZ
(ING 4)
Protective Gloves:NATURAL RUBB, NEOPRENE, BUNA N, NITRILE.
Eye Protection:ANSI APPROVED CHEM WORKERS GOGG .
Other Protective Equipment:APRON SHOULD BE WORN TO AVOID SKIN CONTACT.
Work Hygienic Practices:WASH HANDS THORO BEFORE EATING & USING
WASHROOM. REMOVE CONTAMD CLTHG IMMED & DO NOT WEAR IT UNTIL IT HAS
BEEN (SUPDAT)
Supplemental Safety and Health
TRADE NAME/PART #: DRIFTWOOD GRAY. FIRST AID PROC:PHYS. CONT PHYS
IMMED. RESP PROT: PARTICULATE & GAS & VAP. IN CONFINED AREAS USE
NIOSH/MSHA APPRVD AIR LINE TYPE RESPS/HOODS. RESP PROT MAY ALSO BE
NE C IN ANY LATER MFG OPERS IN WHICH PROD MAY BECOME AIRBORNE IN
FORM OF VAP/DUST. HYGIENE PRACT: PROPERLY LAUNDERED.

Boiling Pt:B.P. Text:>212F,>100C
Vapor Pres:17 @ 68F
Vapor Density:HVR/AIR
Spec Gravity:1.25
Evaporation Rate & Reference:SLOWER THAN BUTYL ACETATE
Appearance and Odor:NONE SPECIFIED BY MANUFACTURER.
Percent Volatiles by Volume:70.26

Stability Indicator/Materials to Avoid:YES
STRONG ACIDS.
Stability Condition to Avoid:NONE SPECIFIED BY MANUFACTURER.
Hazardous Decomposition Products:CARBON MONOXIDE, CARBON DIOXIDE, AND
OXIDES OF NITROGEN.

Waste Disposal Methods:DO NOT FLUSH TO SEWER, WATERSHED, OR WATERWAY.
DISPOSE OF PRODUCT IN ACCORDANCE WITH APPLICABLE LOCAL, COUNTY,
STATE, AND FEDERAL REGULATIONS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.